EVO Enforcer Pro Stage 1 Suspension System - 2007-2018 Jeep Wrangler JK
- Fast and Free Shipping on orders over $99*
- Available Monday - Friday 6AM - 6PM PST
- No salesmen, Just Enthusiasts.
- Bizrate Circle of Excellence Winner
The EVO MFG Front and Rear LCG Bolt-On Coilover kits come complete with all necessary parts to easily convert the JK from the limited coil and shock system to a far superior performing coilover system. 12”’s of usable wheel travel, custom built brackets for the lowest center of gravity, EVO’s legendary SPEC valving and spring rates specifically dialed in for the JK to yield excellent handling. The EVO MFG LCG Bolt-On Coilover system proves to set the bar, for ease of install, price and performance. LCG 3”-5” recommended lift height, fully adjustable minimal drilling/cutting required, fully bolt-on Hi Clearance design. Retains all factory rear exhaust system as well as factory front and rear swaybars.
The EVO MFG Adjustable Front Lower Control Arms are made from 2.00” x .281” wall DOM tubing, feature complete on car adjustability without removing mounting bolts. This adjustability allows for caster adjustments to be made completely while installed on car to dial in your handling and caster alignment with ease. No need to remove the control arm to make adjustments. Currie Johnny Joints are used on both ends of each arm, rebuildable, greaseable, and isolated construction for decreased transmission of road vibrations.
The EVO MFG Draglink Flip Kit raises trackbar mounting location 3” at the axle to help correct roll center and steering angles of a lifted JK. Roll center is greatly improved giving better handling/ steering response of the vehicle on and off road. The EVO MFG Drag Link Flip Kit features an improved steering stabilizer mounting location to get it up and out of harm’s way above the tie rod.
This package is the ultimate in budget conscious extreme on and off road performance.
Click HERE for installation instructions.
High Clearance Fenders Recomended
2Door JK: Front (or exhuast spacers) and rear aftermarket driveshaft required. Rear Adjustable Upper control arms should be used in addition. Recommended purchase of EVO-201-2 (stage 2 kit) or EVO-201-3 (stage 3 kit), or EVO-1174B EVO MFG Enforcer Rear upper control arm set
4Door JKU: Front aftermarket driveshaft required or exhaust spacers, rear recommended. (not included)
Recommended wheel backspacing 3.75” or less (smaller backspacing #)
No cutting/permanent modifications of exhaust required
EVO Enforcer Pro Stage 1 Suspension System - 2007-2018 Jeep Wrangler JK fits the following vehicles:
- 2007 Jeep Wrangler JK
- 2008 Jeep Wrangler JK
- 2009 Jeep Wrangler JK
- 2010 Jeep Wrangler JK
- 2011 Jeep Wrangler JK
- 2012 Jeep Wrangler JK
- 2013 Jeep Wrangler JK
- 2014 Jeep Wrangler JK
- 2015 Jeep Wrangler JK
- 2016 Jeep Wrangler JK
- 2017 Jeep Wrangler JK
- 2018 Jeep Wrangler JK