RT Pro RZR 800 S/4 Seat 2 Inch Lift Kit - All Years

RT Pro is proud to present the first lift kit that WILL NOT cause any CV issues for the remainder of the life of your RZR. RT Pro achieves this by relocating the UPPER shock mounts and not the lowers. This method improves the shock angles which require a lower spring rate to hold the vehicle at ride height. When retaining the stock springs however, the ride height is raised. This kit will allow you to back the "clickers" on your shocks down and still have the desired height needed for that additional ground clearance. So you get two things with this kit. A taller ride height PLUS an improved ride! Actual height gains will vary but expect approximately 1.5” rear lift and 2” front. We’ve found our best performance with these machines by setting the fronts 0.5-1” taller.

OEM springs are known to sag. If you end up with less lift than expected and still have stock springs this may be the problem. The best ride and handling is usually found with the kit set at only about 1" of lift so this might still be alright for you. If you don't get all the height you want, consider one of our replacement spring kits for your model. The combination of a lift kit with our replacement springs is the ultimate best bang for your buck when it comes to getting the ride height, handling and smooth ride you want without spending the big money on aftermarket shocks.

This kit is all bolt-on and the installation can be completed in less than 1.5 hours. There are four holes to be drilled in the rear of the frame for the ultimate in strength but this job is made simple by the very thorough instructions this kit comes with. This kit comes complete with all necessary components, hardware and instructions for complete installation. Kits are powdercoated black. Custom colors are not available.

FITMENTThis kit will fit all years RZR S 800, RZR 4 800 (Including Robby Gordon Edition). It will work with any OEM shock option.

Note: A very small percentage of 2012+ Canada and Mexico built RZR's have some hole alignment issues with our rear lift brackets. This is a minor issue and VERY rare. However, we have addressed this in our instructions and have a alternative solution for the customers who may not have the means to install on these machines. Please note this is ONLY a potential issue for 2012+ RZR's and is EXTREMELY RARE and MINOR.